Cover for oil sidelights and tail lights, sold each.Made of cotton backed with flannel to prevent tarnishing, scratching and protect your brass parts.Made in the U.S.A.

With this new T-VAC tool you can diagnose many of your Model T's performance issues without having to relay on trial and error guesswork! It will help you find the cause of such problems as why you car runs erratically or won't idle, or has low compr...

This is an exact copy of the original spoke straightener. Very useful tool to get those bent spokes back into position.

Drive shaft front bushing puller, removes from the drive shaft tube

Universal Joint installation tool. A neat copy of an original Frank Mossberg Co. tool that makes putting the U-Joint (when installing the rear end) into the back of the motor a snap. We added the open end to allow it to be used from under or above th...

Piston ring compressor, For mounting the piston with rings easily in to the engine liner

Set of 3 wrenches needed for adjusting double lock or single lock tappets T-3058-T

Drive Shaft Bushing Driver. Use to assist in installing the bushing in the drive shaft torque tube

50 page booklet.

T-17005Size 22 x 36 cm

Brass Ford models

For Nickle plated Ford models1916 - 27

Only 1909-25 models

Remove pitman arm.Remove spark arm and pin.Remove steering bracket.Remove throttle arm and pin.Remove spark and throttle rod guide.Place tool on rod and compress spring all the way.Lock thumb screw.Remove pin, washer and spring assembly

Threads into the spark plug hole and gives you a nice eye to hook into for pulling or installing an engine

Plastigage takes the guess work out of putting the proper clearance in rod and main bearings. A must when checking or adjusting bearing clearance. Toepasbaar:.001 - .003 inches.025 - .076 mm

A handy multi-function tool. Used for opening & closing the fuel and oil petcocks, checking gas, and has a pin on the end for cleaning out the petcocks. Wooden handle.

This handy tool allows you to check the oil without getting under the car. Opens and closes petcocks on the crankcase

K.R. Wilson figured out that the normal clearance setting of the valve was not the way to get the most out of the model-TWith this tool you can set the valves by the piston travel. There will be a full disription encluded with this setting tool

Pulls the clutch disc drum from the transmission shaft and can also be used for removing the driven gear from the brake drum shaftT-Ford 1909-27T-3317-T

Hooks over manifold stud and makes removal or placing the valve pin very easy T-Ford 1909-27  

When installing new spindle bushings, the face of the bushing must be cut to fit. This tool slips inside the bore of the bushing and faces the head properly

When new bushings have been installed they must be reamed for the spindle bolt to fit. This special reamer reams both upper and lower bushings at the same time so they are aligned with each other. This reamer is specialy madefor the model TT-Ford 190...