Needle and seat with viton tip for the Holley NH and Vaporizor carburetors Ford 1914-27 OEM: T-6220

Used on the later style Kingston carb that did not have the raised bead around the air inlet. Ball style valve that replaces the original needle/seat assembly. This style was used on the 1917-18 Kingston carbs. Threads = 7/16-24. U.S.A.

Kingston L4 carburateurT-Ford 1921-26OEM: 6172

New material used for this vaporizer plate. Will last longer than the original one Ford 1926-27

Sets around the primary air tube behind the heat plateReplaces T-6277

T-Ford 1926-27 OEM: T-6259

Holley NH adjusting needle T-Ford 1926-27 OEM: T-6213-B

This adjusting needle clamping nut was only used on the 1926-27 NH carburetor OEM: T-6208-B

T-4131T-Ford 1926-27

Adjusting needle for the VAP carb. T-Ford 1926-27 OEM: T-6279

T-Ford 1926-27 Vaporizer carburetor OEM: T-6283

This is the long tube that runs from bowl of the vaporizer carb up to where the butterfly is. Made of stainless steel for longer life T-Ford 1926-27 OEM: T-6276

T-Ford 1926-27 Vaporizer carburetor ​OEM: T-6269

Nut for T-6269 outlet tube T-Ford 1926-27 Vaporizer carburator ​OEM: T-6271

In 26-27 the T's did not have a separate rod to choke the carb. This sleeve slips up the carb control beyond the cotter pin hole. A piece of wire goes from this sleeve down to the choke arm so when you pull up on the carb control, you choke the c...

Sediment bulb and shut off for gas tanks mounted in the cowl. Cast Brass and black powder coated to prevent corrosion. This is a excellent reproduction made in USA. It is much better quality than the foreign reproductions on the market. NOTE: 1926-27...

Service kit for the original firewall mounted cast iron sediment bulb. A-Ford 1928-31 T-Ford 1926-27 OEM: A-9155-RK

Ford 1909-27T-2902-B

Height 64mm. pipe dia. 5.5mm (were it slides into the sediment bowl). 9.5mm screen diam.

Fitting is 1/8" pipe thread where it enters the carb. This modern version uses a compression fitting to seal the gas lineFuel line: 1/4" (6.2 mm)

Replaces the elbow fitting where the fuel line enters the carb. Sure beats crawling under the car to shut off the gas

Electronic fuel valve shut off, modern style, 6 volt. Shuts off the fuel to the carburetor with the ignition switch, battery disconnect switch, or an under the dash toggle switch. No more forgetting to turn off the manual valve. Easy to install, incl...

T-2901

Gas cap, 2 piece with air vent splash guard as original, die cast metal, excellent quality. Comes with gasket (also used on Fordson Tractors)

Ford 1909-27T-2903

Ford 1909-27

Set of 2 felts, goes around the fuel line at each end of the lineused with nut H7357

Feed pipe gasket, neoprene, replaces felt gasket

Galvanized gas tank, for the Sedan, and measures 18-3/4" wide x 8" high x 17" long. Does not come with the cap

From carburetor to radiator front