This is the small clip that sticks out the bottom of the bucket that the "T" bar hooks onto to hold the rim on. A-Ford 1928-31 OEM: A-13047

Repair two damaged rim latches with this all-chrome Kit. Instructions included.

15 mm

ba15D

A-Ford 1928-31 Ford V8 1932-39 OEM:A11654B, A11655/67

Mounts on bottom of steering column. The light wire harness slips inside this unit to turn lights off and on. This is not the poor functioning import unit, this is a quality American made switch assembly made to the archive blueprints A-Ford ...

Goes on end of light switch rod that fits into switch bodFord 1928-38

Small U shaped retainer that holds the spider on the rod A-Ford 1928-31 OEM: A-3644

This is the spring that holds tension against the spider to hold the light switch rod in place A-Ford 1928-31 OEM: A-3642

This is a non returnable product - READ INSTRUCTIONS CAREFULLY. Designed for low amperage loads - 4 Amp maximum and 2 Amp minimum loadVoltage reducer with resistance wire mounted on a ceramic back plateMounts under dash or motor compartment.Caution: ...

If you are needing to rebuild your horn, this kit will do the trick. Includes: Diaphram, screen, bracket, gaskets, brushes, springs, adjusting cover and flange bolts and nuts

The screen that fits into the end of the horn bell. Keeps out the bugs and dirt. Diameter: Ø 70 mm A-Ford 1928-31 OEM: A-13840  

A brand new horn complete with the mounting bracket and the horn plate. Comes already painted with black powder coat paint OEM: A-13802-R6 A-Ford 1928-31

A brand new horn complete with the mounting bracket and the horn plate. Comes already painted with black powder coat paint

Antique car Horn Assembly - 12 Volt - Painted Black With Universal Mounting Bracket - Not Authentic to a Model A ford

Identificaton plate mounts on top of the Sparton horn housing. A-Ford 1928-31 OEM: A-13802

Buffed stainless steel cover. Designed to use your remote switch. Includes stainless arm & blade. Wiper blade lenght: 21 cm.Wiper arm lenght: 19.5 cm.Shaft wiper motor to end of wiper blade: 30 cm when mountedMotor has automatic stop

electric wiper kit that is a direct replacement for the old electric or vacuum wiper motor that mounted to the outside of the closed car windshield frame. The windshield can still be opened (about 2-1/2 to 3 inches) for fresh air. Motor will accommod...

Quickly Mounts to Under Dash Flange On Most Cars & TrucksHeavy Duty Toggle Switch With Chrome HandleUse for Fog Lights, Wiper Motors or Any Universal UseOn-Off-On SwitchUse For 12V Or 6V Systems

A14560P

Set with 4 bolts and washers to mount the terminal box against the firewall A-Ford 1928-31 OEM: A-14560-MB

Ford started out using this flat copper ground strap

This special headed bolt was used to attach the ground strap to the cross member of the frame A-Ford 1928 till March 1930OEM: A-14301-BT

Correctly braided and colored fabric cable that runs from the battery to the starter. 19" LongOEM: A14300F

35 qmm. wire, 16 inch Long w/ eyes on Each end. 1 on disconnect switch, 1 on starter switch for a A-FordBut also work for other brands or applications

2 x M10 connection cable19 mm dashboard mounting hole

This bracket uses the lower starter mount bolt for mounting. Provides a perfect mount for the disconnect switch between the frame and the starter.

Fits to the H7251 master switchØ 60 mm ODØ 20 mm ID

Mounted on the crossmember of the frame A-Ford 1930-31 OEM: A-13480-B