A9447

Complete Set of jets, needles, & float valve to rebuild the original Tillotson Carburetor. All the needles, jets, and float valve for the Tillotson carb. This kit only works on pot metal Tillotson carbs with the bowl that is held on with 3 screw...

Cadmium drain plug for Tillotson and Zenith 1930 - 1931

A-Ford 1928-31A9611

Screw with cap and stainless spring for Tillotson carburetorA-Ford 1928-31A9577T

A-Ford 1928-31A9534T

Brass Seat, Stainless Needle, and Fiber Gasket included.A-Ford 1928-31A9533T

Replaces original needle and seat. Uses 2 balls to shut off gas flow.A-Ford 1928-31A9564GJT

A-Ford 1928-31A9550T

A-Ford 1928-31A9610

A-Ford 30-31A9559C

Complete Set of jets, needles, & float valve to rebuild original Zenith carb. Incl. gasket Sets.A-Ford 1928-31A9595Z

1932 modelsA9502B

Zenith 1932 B Carburetor Kit.

Std. Diameter 9/32"". If shaft & lever are worn replace it with this new standard one. .281 Diameter.

O.S. Diameter 19/64"". If shaft & lever are worn replace with this new oversized one. .294 DiameterA-Ford 1928-31

Carburetor housings get worn where the throttle shaft goes through. These knurled bushings bring holes back to size. Some machine work to be done.A-Ford 1928-31A9581BU

Screw with cap and stainless spring.A-Ford 1930-31A9577BMB

Screw with cap and stainless spring. The 28 to Mid 1930 are brass with large heads.

New Set needed when you clean the internal channels of a Zenith Carburetor. Drill out the old ones, then peen new ones in placeA-Ford 1928-31A9576

A-Ford 1928-31A9575

A-Ford 1928-30A9559B

Remove the guesswork on your Zenith carburetor. This set shows the gas level in carb. bowl, so float level can be adjusted. Should be 5/8 inch below gasket.A-Ford 1928-31

A-Ford 1928-31A9709

Cadmium adjustment needle driver for the carburetor

The sleeve that holds the choke rod on at carburetor - CadmiumA-Ford 1928-31A9705