2 bushings fit in the housing where sector goes through. Ream to 1.125 inch (28.57 mm)A-Ford 1928-31A3576C

A new sector housing for the two tooth steering box so no core is required! Housing is fitted with needle bearings and a lip type seal to keep the oil in the box where it belongs A-Ford 1928-31 with a 2 tooth steering box OEM: A-3548-N

2 teeth Steering sector shaft for LH drive A-FordsThe sides of the sector should touch the worm and not the tops of the teeth.A3575C

Special sector for the right hand drive Model A's using the 2 tooth steering box. A-Ford 1928-31 OEM: A-3575-CRH

Ford 1928-1936 OEM: A-3577 2 tooth steering box

This is a very well made FORGED steering arm. Original length, A-Ford 1928-31 OEM: A-3590 Made of SAE4130 chrome moly steel

38 mm shorter than the stock pitman arm, which makes for easier steering. A-Ford 1928-31 OEM: A3590-S Made of SAE4130 chrome moly steel

Special bolt used to attach the pitman arm to the sector shaft on the steering box.

A3524CD

For the steering worm bearing on the later 2-tooth boxes. Heavy metal piece that the adjusting bolt presses against and has the bearing race machined into the bottom A-Ford 1929-31 OEM: A-3553-D

2 tooth sector - Bore the end of the sector that bolts to the frame to .250 deep and 1.625 diameter to install seal. Press in the neoprene seal to stop the oil from dripping out of the sector. This seal is an after market improvement. Included with A...

Special dish washer fits between sector and steering box on 2 tooth models. Raised center points toward pitman arm end.A-3579

Three special extra wide lock washer set, locks the steering housing to the gear box. Also one washer for eccentric adjusting studA-3583L

One end clamps on the tie rod, and the end mounts to the front axle. You do not have to drill a hole through the axle to mount this unit. This unit dampens the steering and gets rid of that nasty shimmy.Ford A and T1909 to 1931

For 2 tooth steering gear assemblies. Replaces the end plate on the steering column and has a tube that goes above the oil level to avoid leaksFord 1926-36A3568T

Complete gasket set for the 2 tooth steering

For 2 tooth steering worm. 2 needed

The lower steering worm bearing cup. 2-Tooth box. A-Ford 1928-31 OEM: A-3552

The oil fill box on the top of the steering box for the 2 tooth box. 1/4" thread A-Ford 1928-31 OEM: A3538  

A-Ford 1928-31 ​OEM: A-3584

Mounts in the 2-tooth sector housing for adjusting the sector A-Ford 1928-31 OEM: A-3586

One of these studs with shoulder is used on the 2-tooth box A-Ford 1928-31 OEM: A-3585

This cone fits around the special stud and down inside of A-3586 (H28800) for adjusting the sector shaft 2 sector steering box A-Ford 1928-31 OEM: A-3587

This holds de light switch body to the bottom of the steerin columnA-Ford 1928-31

Basic rebuild kit for Ford A & B 1928-342 sets required per car

You can remove the threaded end plugs on the tie rod and drag link ends with this tool. Use 7/8"" wrench

kit with 4 sealsA3332

This cap holds rubber seal (H8696) in place Set contains 4 steel caps

Replace your worn white teflon seats with these new spage age Bronze impregnated seats.A far superior quality productA3305BRZ