The new Delco style alternators with build in voltage regulator are an direct fit to the model T engine and will replace the old generator with the cut out assembly. These new alternators puts out 40 amps. Only fits to LH drive model T's 

This semiconductor (state of the art) unit modernizes and replaces the original relay type of past years. It is identical to original exterior appearance and dimensions and is plated in cadmium as original. Also includes authentic insulators and hard...

This semiconductor (state of the art) unit modernizes and replaces the original relay type of past years. It is identical to original exterior appearance and dimensions and is plated in cadmium as original. Also includes authentic insulators and hard...

Standard Cut out control6 Volt system onlyPositive earth ground

Convert your standard "point" style cutout to a diode style. A diode will eliminate the problem of sticking points. Comes with instructions. For negative ground systems only. T-Ford 1919-27 OEM: T-5055-DIO

Ford 1919-27

Ford 1919-27T-5143

Ford 1919-27T-5133

Ford 1919-27T-5123

Thin brass 1/4" nut that attaches the cutout to the generator terminal and holds the terminal to generator T-5123-N

T-3266

T-5107

Battery cable insulator. Model T starterT-5109

Model T startermotor

T-5025

T-3380

T-3381

Special srew to bolt down the generator coil winding on the Model T and A generatorA-11086

T-5056

T-5022

T5026

T-5021-PS

T-5018  

T-5020

T-Ford 1915-27 OEM: T-5021

Goes at the very end of the starter drive. This piece has a key slot on the ID and one of the spring bolts goes into thisT-50191919-27

Starter Bendix drive gear with balance ring T5023

Set with 4 insulatorsT-5108

Set with 4 brushesT-5104

T-5106