This heavy felt pad fits tightly around the steering collumn and the pedals when usd with the H8714 steel plate
Powder coated for durability. Well made reproductions complete with support studs
Ford Aug. 1928 tot Mei 1929
Exact duplicate of the battery hold down clamps Ford used from 1930-32. These hold the battery by the corner only. (Can be used for any year.) OEM: A-5163-B
This cover goes over the hole in the floorboard, were the battery sits130 mm wide
This cover goes over the hole in the floorboard, were the battery sits105 mm wide
If you are running one of the 6-volt Optima batteries in your Model A, this hold down bracket holds the battery securely in place using the battery hold down studs
Economical version for installing a 6 Volt optima on to the battery box
These are the special oversized head bolts that get welded or brazed to body to mount the rear fenders on. 4 Studs needed per fender.
This gasket goes on the bottom - put in first - & sides of the steel windshield frame. Rubber gaskets stretch when you install them so wait a day to trim for a tighter fit
This gasket is critical to keep out water. It fits between the windshield hinge & the header. Not for Slant Windshield SedansLenght 4 ft. A18058
These arms have notches in them so that the arms are sure not to move or slide
This kit combines an anti rattle and brake lever spring.This will stop your stoplight from sticking and staying on.With mounting instruction
This cleviis pin is designed so you can hook up the stop light switch to it.Used 1928 thru July 1929
Solid bronze bushing, To be used with bracket H8688OEM: A2477B
This complete bracket set is used to attach the brake cross shaft to the frameBushing H8687 can be used Set contains 2 pair of brackets
A7000EB
Late style bumper clamp in stainless. A-Ford 1930-31 OEM: A-17758-SS
Instead of the messy paint we can offer these self adhesive stickers. Just cut'em out and stick'em on. Washington Blue. One sheet is enough to do 4 large clamps
Center bumper clamp used on the model A Ford from 1928 up to May 1929 A-Ford 1928-29 OEM: A-17762-B
This small clamp goes in the middle of the bumper bars to keep them from vibratingUsed until april 1928
The oval style center clamp was used from November of 29 until the end of production. Either the chrome or the stainless are period correct. Only 1 used per car in middle of front bumperOEM: A-17762-S
This is the wider backing plate for the center bumper clamp mount Width: 38 mm A-Ford 1928-29 OEM: A-17765-A
This is the smaller backing plate for the center Oval style bumper clamp Width: 22 mm. A-Ford 1928-31 OEM: A-17765-B
All the correct sizes you will need for one compelete A Ford
These rubber pads are nailed to the body mount blocks to align doors and hoodA5000P
These rubber pads are nailed to the body mount blocks to align doors and hood