A-Ford 1928-31A9709

Cadmium adjustment needle driver for the carburetor

The sleeve that holds the choke rod on at carburetor - CadmiumA-Ford 1928-31A9705

The lever only for the choke shaft. Available in the early cast brass style or the later cad plated stamped steel design

Carburetor Choke Shaft Lever - Zenith or TillotsonA9548

A-Ford 1928-31A9547

Set of four small fine threaded screws that attach the choke and throttle butterflies to the shafts OEM: A9549MB Carburetor: Zenith A-Ford 1928-31

Brass adjustment needle works off choke rod. It is critical for good performance. Inserts into A9528. Push needle hard into housing and screw together.A-Ford 1928-31A9525

The adjustment needle went into this brass seat in the 28-9 Zenith carbs. The later carbs were machined in the carb casting and didn't use this one. Don't get this seat confused with the A-9575 compensator jet! This jet has a taper for the A-...

Sept 1928 to end 31A9586

For the Zenith carb only. The needle has a Viton tip for improved fuel shut-off A-Ford 1928-31 A9564C

Zenith carburetorA9585

Special tap to clean jets on Zenith carburetor. This is a 5mm 75 Pitch tap

A-Ford 1928-31A9550

Made for Zenith & Tillotson carburetor to protect the adjustment needle. Correct 13/32"" Hex sizeA-Ford 1928-31A9528

A-Ford 1930-31A-9230-B

A-Ford 1928-31A9534B

A-Ford 1928-31A-9538

A9545

A-Ford 1928-31A9542

A-Ford 1928-31Will not fit the last cars of 1931A-9240-B

For Late 1931 Model A with indented firewall.Starts from May 1931 till endA9240C

A-Ford 1928-29A-9230-AR

A-Ford 1928-31A-9243Also useable as a universal collet. 1/4" tube. 1/2" outside tr.

A-Ford 19319/16" fiitingA-9243-B

Service kit for the original firewall mounted cast iron sediment bulb. A-Ford 1928-31 T-Ford 1926-27 OEM: A-9155-RK

A-Ford 1928-31A-9155

The brass screen for the glass type sediment bulb. Goes between the bowl gasket and the bulb housing

Fits to a sediment bowl with 52 or 54 x 59 mm glass height