T-3271T-Ford 1909-27

T-3363T-Ford 1909-27

T-3315T-Ford 1909-27

8 pc bushing set for a complete transmission overhaul T-Ford 1909-27

Ring gear held by the 16 magneto screws to the flywheelOEM: T-3268

Basket set, Used for mounting the transmission cover in a model T T-Ford 1909-27 OEM: T-3363-GS

Pulls the clutch disc drum from the transmission shaft and can also be used for removing the driven gear from the brake drum shaftT-Ford 1909-27T-3317-T

Holds transmission brake drum to the drum shaft. 8 per drum are required Sold induvidually Rivet: Ø 6.3 mm x 22 mm x 60 degree head OEM: T3311-RB

Special Rivet used for the slow speed drum and the reverse drum  8 Used per drum Sold induvidually Rivet: Ø 5.5 mm x 22 m x 60 degree head OEM: T-3311-R

These special rivets hold the shaft to the driven plate assembly. The driven plate is the one with the fingers mounted on for adjusting the clutch. 8 are required sold induvidually Rivet: Ø 6.3 mm x 22 mm x 60 degree head OEM: T-3321-R

Two of these pins are required for holding the clutch fork arms onto the clutch shaft T-Ford 1913-1927 ​OEM: T-3406-C

For the clutch disc drum. Secures it to the transmission gear shaft. T-Ford 1909-27 OEM: T-3334

The key that fits into the transmission gear shaft for locating the clutch disc drum, T-Ford 1909-27 OEM: T-3333

T-Ford 1909-25 OEM: T-3337 Small slotted screw that screws into the clutch adjusting finger 3 required per car

This soft plug in the driving plate sleeve that prevents engine oil from leaking into the drive shaft and onto the rear axle. T-Ford 1909-27 OEM: T-3324-B

T-Ford 1909-27 OEM: T-2579 Thread: 1/4" Diameter cup: Ø 34 mm

Special copper type ring gasket for the oil plug T en A Ford  OEM:, A-6734-C Inside diameter Ø 19 mm

Magnetic oil drain plug. 3/4-24 thread Ford 1909-31

14 cadmium plated rear axle and drive shaft nuts T-Ford 1909-1927 OEM: T-2500-CAST

If your oil pan supports are cracked or broken, these can be welded to the supports to give them extra strength. Even if your supports are in good condition, these will give added strength when welded into place. Pan must be removed to install these....

This special short castle nut holds the pinion gear to the Drive Shaft T-Ford 1909-27 A-Ford 1928-31 OEM: T-2598