Simply unscrew the timing pin from the front of the engine and screw in the Ford- A-Time tool until it starts to beep then turn it in a 1/4 of a turn. Using your hand crank turn the engine slowly until the Ford-A-Time tool stops beeping if you pass t...

Holds the cam in place so that you can tighten the cam screw after you set the ignition timingA-Ford 1928-31

A simple tool to adjust and set the model-A distributor,Complete with instructions

Not a generic fender pad, this one is made just for model A's. Contours to the model A fender and has a slit and hole to go around the headlamp bar so it will stay in place while you work on the car  

Lay this pad across your rear fender when people are getting in and out of the rumble seat to protect the paint. Rumble step plate keeps it from sliding off A-Ford 1928-31 with rumble seat

After removing your gas cap, simply place the mirror around the filler neck, magnets will hold the mirror against the top of your gas tank. The back vertical portion of the mirror allows you to see the fuel level as you fill the tank

Lay this lined naugahyde on top of tank when filling to protect the finish

This tool is a must for putting new wheel studs in your Model T or Model A. These studs don't just push in place like modern studs. These studs will just push through the hole, and the shoulder of the stud actually gets squashed against the drum. Thi...

Special tap to clean jets on Zenith carburetor. This is a 5mm 75 Pitch tap

This is an exact copy of the original spoke straightener. Very useful tool to get those bent spokes back into position.

A great new tool to keep under your seat for adjusting your brakes in a hurry. Complete instructions included

Wrench with good design to install or remove the pinion nut A-Ford 1928-31 Width for nut: 38 mm

Piston ring compressor, For mounting the piston with rings easily in to the engine liner

Steel plate Size 15.5 x 30.5 cm Last one available

These brackets are used for attaching the front license plate to the headlamp bar. A-Ford 1928-31 OEM: A-13145

Accessory bolt/nut set for mounting the license plate to the USA style slotted mounting bracket

Last one available

Aluminum cast with chrome frames w/ white lettering show the year of, and your pride in, your A

An special tool kit to remove and install the fuel gauge on the dash.

Used to remove engines and stock cylinder heads

This adapter can screw onto a regular gun to enable it to be used to grease the old style grease fittings

You can remove the threaded end plugs on the tie rod and drag link ends with this tool. Use 7/8"" wrench

Will do 7/8" or 22 mm spark plug holes