A-Ford 1928-31. 9.5 mm diameter bolt (3/8" -24 Bolts) & Tab Washers. Thin headed Bolts with Special washers holds drive shaft & spring. Ford used two sizes so make sure to measure yours."OEM: A11382S

A-Ford 1928-31. 7.9 mm bout (5/16"-24 Bolts) & Tab Washers. Thin headed Bolts with special washers holds drive shaft & spring. Ford used two sizes so measure carefully.OEM: A11382SE

A-11375

Handy tool for installing the new type starter drive. This will compress the drive so you can get to the mounting screw easier

A-11082/85

A-11082-12

A-11481-B A-Ford 1930-31

A-11480-A

Replaces A-11125

Ford USA 1928-64 Set with 4 brushes to do one startermotor A-11054-S

Spring that keeps the brush against the armature A-Ford 1928-31 OEM: A-11059

A-11450

The head of this rod is what you push with your foot to start the vehicle A-Ford 1928-31 OEM: A-11470

A-Ford 1928 - early 1930A11450G

Thin paper insulator that protects the copper contact bolt and strap from shorting against the stamped steel housing A-Ford 1928-31

The 4 screws and 4 lock washers needed for mounting the starter switch. Improper screws can cause a short against the fields A-Ford 1928-31 OEM: A-11450-MB

Special srew to bolt down the generator coil winding on the Model T and A generatorA-11086

Used between the Starter and the Bell housing to adjust the gear meshingA-Ford 1928-31A11130SH

A must have safety device for your ford. Installs easily on the starter switch using the same starter switch mounting holes.

When adding a safety fuse, you will need these two longer screws with the lock washers to mount it A-Ford 1928-31

30 Amp fuse to replace the fuse on the fuse block mounted on top of he startermotor A-Ford 1928-31

The best way to go when running a 12 volt system. Direct replacement of the factory starter except you will need to change your wiring. You will need to add a push button style starting button which you can get from your local parts store. Unit is ve...