OEM model lightswitch, with resistor, 4 positions. For tractors with regulators, not cut-outs

OEM model lightswitch, with resistor, 4 positions. For tractors with regulators, not cut-outs

4 position rotary light switch for models with a cut out relay.Fits model: A, B, C, Cub, H, M, O en WOEM: 57310DX and 57310DYFor models with 6 Volt, CUT OUT relay, NOT voltage regulator CUT OUT RELAYS WILL HAVE 2 TERMINALS ON 1 SIDE & 1 TERMINAL ON T...

Fits most French made Farmall tractors with the Ducellier distributor. Inside diameter distributor 80 mm, , keyway is 29mm ,

Replacement for the original Ducellier rotor. This item does not look exact the same as the original one, but it works great. Diameter rotor shaft 15.5 mm

Point set, specially for the French Ducellier distributer, Fits Cub etc.Farmall FC, Super FCC. Jeu de RupteursOEM: 757259R91

Fits listed IH models when equipped with IH brand distributor 353898R11.A, A1, AV, AV-1, B, BN, C, Cub, H, HV, I4, I6, I9, ID6, ID9, M, MD, MDV, MV, O4, O6, ODS6, OS6, Super A, Super AV, Super C, Super H, Super HV, Super M, Super MD, Super MTA, Super...

Used for Delco distributers Lenght Clip: 57.15 mmBracket: 17.8 mm

Used for Delco distributers Lenght Clip: 57.15 mm Bracket: 22.9 mm

For the models that are using the IH horizontal distributor (353898R11). Please note, this cannot be used on Cub models that have a J4 magneto. Will also fit distributor # 368051R1 & 401107R1353900R11

For Farmall with battery ignition model: A, AV, AV1, SUPER A, SUPER AV1, B, BN, C, SUPER C, CUB, CUB LOBOY, H, HV, SUPER H, SUPER HV, M, MV, MD, MDV, SUPER M, SUPER MD, MTA, W4, W6, W9, WR9, WR9S, WDR9, O4, O6, OS6, ODS6, I4, I6, ID6, I9, ID9, T6, TD...

Fits J-4 magneto ( Cub) and J-4 battery ignition

Insulator fits the J-4 mageto and the J-4 battery ignition

Point Gap = 0.013" (0.35 mm) Fits IHC J4 magneto and IH 353898R1 distributors

For Farmalls with petrol engines and J-4 battery ignition: A, AV, AV1, SUPER A, SUPER AV1, B, BN, C, SUPER C, CUB, CUB LOBOY, H, HV, SUPER H, SUPER HV, M, MV, MD, MDV, SUPER M, SUPER MD, MTA, W4, W6, W9, WR9, WR9S, WDR9, O4, O6, OS6, ODS6, I4, I6, ID...

For models with a Delco Remy distributor ignition

Allis Chalmers - B, C, IB, RC, WC, WD, WF (Met Delco verticale ombouw verdeler 1111411), CA, D10, D12, D14, D17, D19, G, WD45 (Met Delco verdelere & Clip Held Cap) D15, Vervangt: 225734, 70225734 Case - D, DC, DC-3, DC-4, DCS, DEX, DH, DI, DI/NAR,...

353874R91

353875R91This distributor coil has a 2.8 ohm rating between the two primary winding terminals. Requires an external resistor ( Item H10749)

Universal igintion coil fits all 6 volt distributor systems

Internally resistedIncludes coil mounting bracket3.1 Ohms Resistance Primary9.6 Ohms Resistance Secondary

This set contains the rotor, point set and the condensor

Fits magnetos with round retaining bar. The retaining bar (core) is not included; you must reuse your old one. This coil fits the below listed models with the following IHC magnetos: F4, F6, H1 and H4. OEM: 47439DA

Original model H-4 magneto coilcover

Now with brass contacts in the capFarmall A, AV, B, BN, C, H, HV, I4, I6, I9, ID6, ID9, M, MD, MDV, MTA, MV, O4, O6, ODS6, OS4, OS6, Super A, Super C, Super H, Super HV, Super M, Super MD, Super MDV, Super MV, Super W4, Super W6, Super WD9, Super WD...

Complete gasket set for the H-4 magneto, seals the magneto against moisture

Drive Shaft seal Farmall H-4 magneto

Replace the worn gear with rotorholder, and the rotor will be tight again in the distributor cap. 49420DX