A-Ford 1928 tot juni 1930. with oval shaped speedometer Cable ends: Round  Ø 5 mm x square 2.8 mm   OEM: A-17260AU

July 1930  to 1931. with round tachometer Cable ends: square x square 2.5 x 2.5 mm, length 157cm. Replaces: A17260B

This is the shaft only that goes in the gear/case assembly that bolts to the torque tube. The end of the speedo cable slides into this shaft. A-Ford 1928-30, Rounded end tachocableOEM: A-17273-R

This is the shaft only that goes in the gear/case assembly that bolts to the torque tube. A-Ford 1930-31 with square end cableOEM: A-17273-S

This grommet will help save your cable that runs under the gastank in the tunnel to the speedo meter

The mainspring for inside your oval Stewart Warner speedo. A-Ford 1928-30 OEM: A-17318-O

The mainspring for inside your Stewart Warner speedo A-Ford 1930-31 OEM: A-17318-S

The mainspring for inside your speedo A-Ford 1928-31 OEM: A-17318

Stewart-Warner style.Display in Miles

A-Ford 1930-31 with round face clock,Display: Miles

A new dash panel for the price of replating the old one. Nice Chrome finish. For oval speedometer OEM: A-11805-AR

A very nice chrome plated dash panel. This one is for the later round type speedometerOEM: A-11805-BR

Chrome bolt set to mount dash panel. Kit includes eight 10/32 x 1/2 screws, 4 have #10 heads for the 1928-30 style panels and 4 have #12 heads for the later 1930-31 panels

This is an replacement style ignition switch with keys for the original style pop-out switch. Not original but works very well OEM: A-11575-SW A-Ford 1928-32

This is a very good quality off-on switch that has been modified to mount and look like the original pop out style switch. When installed, it looks just like the old pop out switch. Genuine Nu-Rex. Your instrument panel must have the cup crimped to t...

A11556

Chrome lock plate for mounting H9118 plate A11557A

Exact copies of the original Briggs and Stratton ignition key that the 1928-31's used. A universal style key is also available that will work on all years. These blanks only fit the original pop out switches, they do not fit the Re-Pop switches ...

A low pressure gauge for Model A's. Measures 0-10 pounds. ( 0 - 1 Bar) Unit comes with everything needed for installation. Fits any standard 2-1/16" gauge holder bracket 

Mechanical temperature gauge for your A-Ford  This gauge gives you a temperature range of 90 to 250 degrees. The easiest place to mount the probe is to use our A-8273 probe pipe which mounts into the upper radiator hose. Or we offer outlets tha...

Dual gauge bracket that mounts using the same two lower screws that hold the instrument panel in place. Gauge bracket hangs below your dash panel A-Ford 1930-31 Chrome finish