Height: 34 mmSpark plug cable: Ø 7 mm

Straight Distributor/Magneto Boot for 7mm WireShorter verion of our item 40110

Old Style Straight Distributor/Magneto Boot Antique Design for 7mm Wire

Old Style Straight Coil Boot for 7mm Wire Authentic look 

Steel angle sparkplug terminal, Originaly used a lot on vintage tractors, cars, motobikes, stationary engines etc. Chrimp on mounting, No soldering Sold induvidually

Brass high tension wire terminal. Fits over the wire were it is inserted in the distributor cap or coil. Easy mounting, no soldering required. Sold induvidually

Fits to a 7 mm spark plug leadTo be soldered at the end of the terminalHeavy duty connector

Crimped/Soldered Ignition Terminal For 7mm Spark Plug Wire for distributor or coil

Made Of Solid BrassIgnition Terminal For 9mm Spark Plug WireCable: Ø 7 to 9 mm

Easy mounting, without soldering Fits good in combination with ,the M4 sparkplug nut

Easy mounting, without or without soldering

Easy mounting, without soldering Fits good in combination with ,the M4 sparkplug nut

Made Of Solid Brass, Top quality production  Crimped/Soldered Ignition Terminal For 7mm Spark Plug Wire only Fork Inside diameter Ø 5.5 mm

Made Of Solid BrassCrimped/Soldered Ignition Terminal For 7mm Spark Plug WireTop quality

Nickel Plated BrassCrimped/Soldered Ignition Terminal For 7mm Spark Plug Wire

Top Quality Made of Solid Brass Bakelite Cover Ignition Terminal For 7mm Spark Plug Wire

Top Quality Nickel Plated Brass Bakelite Cover Ignition Terminal For 7mm Spark Plug Wire

Top Quality Nickel Plated Brass Bakelite Cover Ignition Terminal For 7mm Spark Plug Wire

High top brass spark plug nut with M4 thread x 24 mm height. Will fit most modern and old spark plugs In combination with spark plug fork item 40112 will give set a very good and special appearance to your ignition system

brass solder type HT plug end terminal, wire passes through centre. for standard 7mm HT lead with copper wire centre.

Old style brass ,spark plug thumb ,nut, Fits most modern sparkplugsM4Sold induviduually

BRASS EYE TERMINAL FOR SPARK PLUG WIRE. Used in the early days as an original way to connect the cable to the plug

Use By Folding Closed Over Wire StrandsInner Diameter: Ø 5 mmOuter Diameter: Ø 10.75 mmPriced each

Straight sparkplug terminal, , Lead srews in. Fits sparkplugs with sparkplug nut installed

Fits on sparkplugs with nut

Original Champion spark plug cap.With 10 K/ohm resistor

Resiatant 5 K. Ohm

Crimping Pliers for Non-Insulated Cable Lugs Terminal type 2 ABS,  Crimp capacity mm² 1.5-10,   

Budget line Crimping Pliers for Non-Insulated Cable Lugs. Crimp capacity mm² 1.5 - 6