7 tooth sector - Bore the end of the sector that bolts to the frame to .150 deep and 1.375 diameter to install seal. 1928-31

2 bushings fit in the housing where sector goes through. Ream to 1.125 inch (28.57 mm)A-Ford 1928-31A3576C

Used on the 7 tooth steering boxes to adjust the end play on the sector shaft A-Ford 1928-29 ​OEM: A3577-R

This is a very well made FORGED steering arm. Original length, A-Ford 1928-31 OEM: A-3590 Made of SAE4130 chrome moly steel

38 mm shorter than the stock pitman arm, which makes for easier steering. A-Ford 1928-31 OEM: A3590-S Made of SAE4130 chrome moly steel

Special bolt used to attach the pitman arm to the sector shaft on the steering box.

Located above the worm. Used only on 7 tooth steering.A3553AR

Brass bushings at the end of the seven tooth steering shaft. ID of bushing is .656 (16.66 mm)A3776C

For 7-tooth style steering boxes. 1928 - March 1930A3524A

Three special extra wide lock washer set, locks the steering housing to the gear box. Also one washer for eccentric adjusting studA-3583L

Left Hand Thread - Housing Only - With BoltFord 1928-34OEM: B3286

One end clamps on the tie rod, and the end mounts to the front axle. You do not have to drill a hole through the axle to mount this unit. This unit dampens the steering and gets rid of that nasty shimmy.Ford A and T1909 to 1931

Same as A-3527-BR except this has a tube welded to it to keep oil from leaking out the bottom of the steering box. these will not fit in all steering columns. Measure the ID of your steering shaft where this fits before you purchase it. The tube on t...

Threaded plug that holds seal in place at the bottom of the 7-tooth steering box where light rod comes through bottom. A-Ford 1928-29 OEM: A-3527-BR

A ground and hardened sector thrust washer for the 7 tooth SteeringA-Ford 1928-29A3579AR

Complete gasket set for the 7 tooth steering

For 7 tooth steering worm. 2 needed. Old part # A3571AR

This holds de light switch body to the bottom of the steerin columnA-Ford 1928-31

Basic rebuild kit for Ford A & B 1928-342 sets required per car

You can remove the threaded end plugs on the tie rod and drag link ends with this tool. Use 7/8"" wrench

kit with 4 sealsA3332

This cap holds rubber seal (H8696) in place Set contains 4 steel caps

Replace your worn white teflon seats with these new spage age Bronze impregnated seats.A far superior quality productA3305BRZ

set with 8 teflon drag link seats  A-Ford 1928-31 ​OEM: A-3305-TEF

Worn steering balls make steering less responsive..cut off old ball, drill hole, insert new ball stud and weld it.4 per car needed

B3285

B3286

7 Tooth sector A-Ford 1928-29 OEM: A-3575-B

Black steering wheel with splines NOTE: All U.S.A. steering wheels are unfinished and require trimming of the molding seam A-Ford  1928-31 OEM: A-3600-BS